Yamaha ax 496 инструкция на русском

• Page 1
  AX-496/396 STEREO AMPLIFIER AMPLIFICATEUR STEREO OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING…
• Page 2
  UNPACKING DEBALLAGE AUSPACKEN UPPACKNING DISIMBALLAGGIO DESEMBALAJE UITPAKKEN Remote control Télécommande Fernbedienung Fjärrkontroll Telecomando Control remoto Afstandbediening Opening and closing the front cover Close the front cover whenever the controls inside the panel are not used. Ouverture et fermeture du couvercle avant Fermer le couvercle avant lorsque les commandes placées à…

• Page 3: Table Of Contents

  Thank you for selecting this YAMAHA stereo amplifier. FEATURES AX-496 85W + 85W (8 ) RMS Output Power, 0.019% THD, 20–20,000 Hz AX-396 60W + 60W (8 ) RMS Output Power, 0.019% THD, 20–20,000 Hz Highly Dynamic Power, Low Impedance Drive Capability…

• Page 4: Caution

  Using this unit with a higher voltage than specified is dangerous and may result in fire or other accidents. YAMAHA will not be held responsible for any damage resulting from use of this unit with a voltage other than specified.

• Page 5: Notes About The Remote Control

  NOTES ABOUT THE REMOTE CONTROL Battery installation Since the remote control will be used for many of this unit’s control operations, you should begin by installing the supplied batteries. 1. Turn the remote control over and remove the battery compartment cover by sliding it in the direction of the arrow.

• Page 6: Connections

  ● Use RCA type pin plug cables for audio/video units except speakers. ● The output (or input) terminals of YAMAHA audio/video units numbered 1, 2, 3, 4, etc. on the rear panel must be connected to the same-numbered terminals of this unit.

• Page 7: Connecting Speakers

  Connecting speakers Connect the SPEAKERS terminals to your speakers with the wire with the proper gauge (keep it as short as possible). If the connections are faulty, no sound will be heard from the speakers. Make sure that the + and – polarity markings of the speaker wires are observed and set correctly.

• Page 8: Controls And Their Functions

  CONTROLS AND THEIR FUNCTIONS FRONT PANEL AX-496 NATURAL SOUND STEREO AMPLIFIER STANDBY POWER PHONES STANDBY/ON AX-396 NATURAL SOUND STEREO AMPLIFIER STANDBY POWER PHONES STANDBY/ON AX–496 TAPE SPEAKERS BASS TREBLE BALANCE LOUDNESS FLAT AX–396 TAPE SPEAKERS BASS TREBLE BALANCE LOUDNESS FLAT CD/DVD TUNER PHONO…

• Page 9
  POWER Press this switch inward (ON) to use this unit. In this state, you can turn on this unit or turn this unit in the standby mode by pressing STANDBY/ON. Press this switch to release it outward (OFF) to completely cut off this unit’s power supply from the AC line.

• Page 10: Remote Control

  REMOTE CONTROL The remote control is designed to control the most commonly used functions of the main unit. If you have a YAMAHA CD player, tuner, tape deck, etc. with remote control compatibility, this remote control will also control their various functions.

• Page 11: Operation

  Playing a source STANDBY STANDBY POWER STANDBY/ON –dB Set to the “ ” position. Press POWER inward (ON). STANDBY POWER If the STANDBY indicator is illuminated, press STANDBY/ON to turn on the power. (The STANDBY indicator turns off.) STANDBY/ON – Turns off.

• Page 12
  Recording a source to tape (or MD) AX-496 Select the source you want to record. REC OUT CD/DVD TAPE TUNER PHONO Play the source. Select the source with the INPUT selector and adjust VOLUME to check the sound output. – –dB STANDBY TAPE…
• Page 13
  AX-396 STANDBY POWER STANDBY/ON Select the source you want to record. – TAPE CD/DVD Play the source and then turn VOLUME up to check the sound output. – –dB Notes on recording ● The VOLUME, BASS, TREBLE, BALANCE, LOUDNESS controls and CD/DVD DIRECT AMP switch (and PURE DIRECT switch for AX-496 only) have no effect on the material being recorded.

• Page 14: Sound Control

  Sound control Adjusting the BALANCE control Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions. BALANCE Using the CD/DVD DIRECT AMP switch You can enjoy the purest possible sound from your CD or DVD player by pressing this switch.

• Page 15: Troubleshooting

  Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions given below do not help, disconnect the power cord and contact your authorized YAMAHA dealer or service center.

• Page 16: Specifications

  SPECIFICATIONS Power Section Minimum RMS Output Power 8 , 20 Hz to 20 kHz, 0.019% THD < > AX-496 … 85W+85W < > AX-396 … 60W+60W Maximum Output Power (EIAJ) (1 kHz, 10% THD) < > AX-496 < > AX-396 Dynamic Power (IHF) 8/6/4/2 <…

• Page 17
  YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VASTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA…

AX-496/396

STEREO AMPLIFIER

AMPLIFICATEUR STEREO

OWNER’S MANUAL

MODE D’EMPLOI

BEDIENUNGSANLEITUNG

BRUKSANVISNING

MANUALE DI ISTRUZIONI

MANUAL DE INSTRUCCIONES

GEBRUIKSAANWIJZING

G B